Remote contr ol pr ogramming – Harman-Kardon HA160-0004-A User Manual

Page 22

Remote Contr

ol Pr

ogramming

Signature 2.0

To program the remote, follow these steps. Note that

it is not necessary to program all keys, only those that

are required to operate the subject device. Keys not

programmed will retain the codes preprogrammed at

the factory.

1. Slide the

Use/Learn

switch e at the top left corner

of the remote to the right so that it is next to

Learn

2. If one of the multifunction buttons is being

programmed press the source button (e.g.,

Vid 1

)

you wish to have this function associated with. If you

are programming a single function key, proceed to the

next step.

3. Press the button on the remote that is to be

programmed. Note that the

Learning LED

will illuminate.

4. Place the 2.0’s remote head to head with the other

remote control whose function is being learned. The

two remotes should be no more than 8 inches apart.

5. Press and hold the button on the other remote

corresponding to the function to be memorized until

the

Learning LED

starts to blink. When the LED goes

out, release the button on the transmitting remote. The

function code has been successfully captured by the

2.0’s remote.

NOTE: If both LEDs flash during a programming

operation, it indicates that the remote’s memory is full

or that the remote codes from the transmitting remote

are not compatible with the unit’s signal format.

6. Continue to program any additional remote com-

mands required using steps 2 through 5. When you have

finished programming the remote, slide the

Use/Learn

switch e to the left so that it is in the

Use

position.

Resetting the Remote Memory

In normal operation, codes for a new device may be

programmed “over” the codes that have been previously

programmed into the remote. It is also possible to reset

the memory for individual keys, or for the entire remote.

When a memory position is reset, the remote will return

to the original factory preset command.

To reset the memory for a specific individual key

location, put the

Use/Learn

switch in the

Learn

position. Press the

Main Power Off

button a and the

button to be reset at the same time. Both the

Sending

and

Learning

indicators will light momentarily. When

the lights go out, the memory has been cleared of the

user programmed code and reset to the factory preset.

Return the

Use/Learn

switch e to the

Use

position

when you are finished.

To reset the remote’s entire memory and return all

keys to their factory preset commands first put the

Use/Learn

switch e in the Learn position. Then

press the

Main Power On

button a and confirm

that the

Learn LED

b has illuminated. While con-

tinuing to press the

Main Power On

button, press and

hold the

Main Power Off

button a button until the

Learn LED

goes off for about 3 seconds. It will then

blink twice. Then release the two buttons. This

indicates that the memory has been cleared of any

user programmed commands and that the original

commands have been restored. Slide the

Use/Learn

switch e back to the

Use

position to return the

remote to normal operation.