Super Systems 9205 Series User Manual
Page 38
Series 9205 Operations Manual Rev A
37
Host 485 (3,4) Mode
This will set the mode for RS-485 communications. This is necessary if the Touchscreen will be
communicating through the Com ports. This setting is fixed at Modbus.
Host 485 Address
This will set the address for RS-485 communications. This is necessary if the Touchscreen will be
communicating through the Com ports. The range is 1 – 247.
Slave 1 485 (5,6) Baud
This will set the baud rate for Slave 1 communications. The list of options is:
1200
14400
57600
460800
2400
19200
76800
921600
4800
28800
115200
9600
38400
230400
Slave 1 485 (5,6) Mode
This will set the mode for Slave 1 communications. This list of options is:
Modbus
Yokogawa
Modbus Host
Slave 2 485 (22,23) Baud
This will set the baud rate for Slave 2 communications. The list of options is:
1200
14400
57600
460800
2400
19200
76800
921600
4800
28800
115200
9600
38400
230400
Slave 2 485 (22,23) Mode
This will set the mode for Slave 2 communications. This list of options is:
Modbus
SSi Analog Input Board
Yokogawa
PLC Type
The list of options is:
Micrologix Modbus
MCMmodule Modbus
DF1 PLC5
DF1 Slik
Passive
Host 232A Baud
This will set the baud rate for RS-232 communications. This is necessary if the Touchscreen will be
communicating through the Com ports. The list of options is:
1200
14400
57600
460800
2400
19200
76800
921600
4800
28800
115200
9600
38400
230400
Host 232A Mode
This will set the mode rate for RS-232 communications. This is necessary if the Touchscreen will be
communicating through the Com ports. This setting is fixed at Modbus.