Super Systems 9205 Series - Manual (Page 15)

Series 9205 Operations Manual Rev A 14
The following table shows the ancillary items and their part numbers.
Part Part Number
3.5" Operator Interface 31296
5.7" Operator Interface 31297
12" Operator Interface 31299
TS Manager/PC Configurator Software 13339
RS485 comms cable for 12.1” and 5.7 “ 20576
RS485 comms cable for 3.5” 20635
Flash Card 31604
Flash Card Reader 13333
RS232 Cable 33027
24V DC Din Rail Mounted Power Supply
31135 or
31137
9205 Controller 13443
Setup
The Series 9205 setup consists of setting the local time if required. As shipped from the factory
the communications ports are set at 19200 baud in Modbus mode.
Time will be set for local time in Cincinnati, Ohio (EST /EDT) or time zone of location of city and
state on sales order. For instruction on adjusting these values, please see Chapter 3 -
Configuration .
Additional Features
The Operator Interface (touch screen) contains a removable compact Flash or SD Card that can
be used to transfer data from the Model 9205 to a computer. It is located on the back of the touch
screen (see
Flash Card & Flash Card Reader section for more details).
Also included is a Utility Software CD that includes SSi’s TS Manager. TS Manager is a utility
program that can be loaded onto any Windows® based computer (operating Windows XP or
higher). This software will allow the computer to read the data from the TS Flashcard, and allow
it to be viewed in a manner that is similar to a strip chart recorder.
Ethernet Connections
The Ethernet connection has three distinct uses. First, should the Operator Interface fail, the
Ethernet connection allows a laptop to be connected via a crossover cable to the Series 9205 DIN
rail mounted unit using Internet Explorer Browser. This connection can act as a LIMITED