Datacard Group RL90 - Manual (Page 78)

72 RP90 Plus E and RL90 User Guide
Site guidelines
When choosing a site for the printer and its supplies, consider these
guidelines:
• Keep all dust, dirt, food, liquids, etc. away from the printer at all times.
• Do not use supplies or cards that have been dropped on the floor or
have otherwise become contaminated.
• Keep paper and foreign materials off the printer.
• Place the printer on a stable platform; keep it off the floor.
• Place the printer away from direct sunlight.
• Place the printer away from heating ducts, blowers, or other air vents.
• Do not use the printer for purposes other than its intended use.
• When cleaning around the printer, prevent debris from entering the
printer.
• Place the printer in a clean office environment, protected from any type
of construction.
• Store all supplies in the original packaging until you load them in the
printer. Keep the original packaging closed.
• Store all supplies in a clean, cool, and dry location.
Operating environment
The performance of the printer and optional laminator is strongly influenced
by the installation location. Using the printer in areas below the recommended
temperatures can cause retransfer errors, while using the printer in areas
above the recommended temperatures can cause errors such as deformation
and retransfer film errors. Consider the following recommendations if you
need to move or relocate your printer.
Relative humidity: 35% to 70%
Temperature: 59° F to 86° F (15° C to 30° C)
Tips – Site selection
• Avoid locating the
equipment in dirty or
dusty environments.
• Do not place in areas
susceptible to strong
vibration or shock.
• Do not place the printer,
optional laminator, or the
supplies in direct
sunlight.