Bend remedy laminator settings – Datacard Group RL90 User Manual
Page 63
Printer error recovery
RP90 Plus E and RL90 User Guide
57
Bend remedy laminator settings
When the laminated card warps concave, the printer bend remedy settings
should be effective in correcting the problem. See
If the laminated card warps convex, set the printer Bend Remedy> Temp
Level to Off and set the laminator’s
Card Fan to one of five settings.
Set the printer Bend Remedy>Temp
Level to Off when laminating cards
that have been printed on both sides.
To set the laminator Card Fan:
1
Press the MENU key on the
laminator LCD display until
“Card Fan” is displayed.
2
Press the ENTER key.
3
Press the RESET/K key to select from five settings: Off, Low, Half,
High, or Full. You may need to experiment with this setting to obtain
satisfactory results.
4
Press the ENTER key to confirm the setting.