Datacard Group RL90 - Manual (Page 47)

Using the LCD menus
RP90 Plus E and RL90 User Guide 41
About the Laminator LCD panel
When you power on the laminator, it begins initializing. The laminator searches for
laminate and then starts preheating. The laminator is ready when the LCD display reads
"Ready" and the Ready light is steady green.
Ready LED (green)
Steady Green The laminator is ready.
Blinking The laminator busy.
Off The laminator stopped because of an error, initialization or
preheating is in progress, or the operator is using the LCD panel to
set preferences.
Error LED (red)
On The laminator may require service or did not power on correctly. To
correct the condition, press the RESET/K and then the ENTER key.
If this does not correct the condition, power the laminator off, and
then back on before calling for service.
Off Normal status
Keys:
MENU Press MENU to access the laminator settings. Continue to press
the MENU key to access the settings in the order listed on the next
page.
ENTER Confirms your selection.
EXIT Exits the current selection and returns you to the previous menu
selection. Press the EXIT key at any time to exit the menu system
and return to "Ready" status.
RESET/K Initializes the laminator after an error occurs. Scrolls through
available values when you change settings.