Datacard Group RL90 - Manual (Page 11)

About the laminator
RP90 Plus E and RL90 User Guide 5
About the laminator
The Datacard® RL90 card laminator is an optional laminating module that works with the
RP90 Plus E printer to add topcoat or patch material to printed cards. Holographic
laminating material is also available for added security and tamper resistance. A printed
card can be laminated manually by simply inserting it into the laminator, or automatically by
transferring the printed card from the RP90 Plus E printer to the laminator module.
The parts of the laminator
Laminator door Open the door to access the laminator cartridge.
Laminator cartridge Holds the laminate material.
Cartridge eject button Press to release and remove the cartridge.
Laminator LCD panel Shows the laminator status and any messages. Use it
to change laminator settings.
Power switch Press the switch to power on the laminator.
Power receptacle Plug in the power cord.
Printer port Connection port for the printer.
Card stacker Laminated cards exit here.
Future expansion port Not used at this time.
Card inlet slot Cards enter the laminator here.
CAUTION:
Do not connect or disconnect the laminator cable while the printer or
laminator are powered on.