Adept EX SmartContoller - Manual (Page 34)

Chapter 3: Operation
6. Set the values as appropriate for your port.
7. Click Accept.
8. Click Done.
9. Click Yes, to write the values to the eV+ system disk.
10. Click Yes to reboot the controller, so the values you just set will take effect.
Figure 3-3. Configuring Serial Ports
RS-232 Connectors
All three types of RS-232 connectors are 9-pin DB9 male (standard PC) connectors. The user-
supplied cable to connect to the RS-232 connectors should be a DB9, F/F, null-modem data-
transfer cable. The pin assignments are the same for all three connectors and are shown in the
following table.
Adept SmartController EX User’s Guide, Rev. B
Page 34 of 96