Chapter 3: operation, 1 connectors and indicators – Adept EX SmartContoller User Manual
Page 27
Adept SmartController EX User’s Guide, Rev. B
Page 27 of 96
Chapter 3: Operation
3.1 Connectors and Indicators
1
2
4
7
9
10
11
18
8
3
5
6
12
13
14
15
16
17
Figure 3-1. SmartController EX Connectors and Indicators
All of the connectors on the Adept SmartController EX motion controller use standard-density
spacing, D-subminiature connectors. For customization purposes, the user needs to provide
connectors of the appropriate gender and pin count, or use optional Adept cables.
1. SD Card Slot
See Installing an SD Card on page 20.
2. Top Three Status LEDs
The top three two-color LEDs indicate diagnostic test, power control, and com-
munication status.
Table 3-1. Controller LEDs
LED
Green Indicates
Red Indicates
OK/SF
System OK
System Fault
HPE/ES
High Power Enabled
E-Stop Open
FW/HD
SmartServo Con-
nection
Read/Write from SD
card
During system bootup, the red OK/SF and HPE/ES LEDs are lit and the red
FW/HD LED blinks. After system bootup, the OK/SF LED should show green. If
the HPE/ES LED shows red, the E-Stop circuit is open. During SD card reads and