Glow-worm Xtramax - Manual (Page 8)

8 4000116705-2
Xtracom Remote Control
Diagram 2
REMOTE
CONTROL OPTION
9091
Setting the Time
• Press button 14.
• Press + or - to set the correct hour.
• Press OK.
• Press + or - to set the correct minutes.
• Press OK.
• Press + or - to set the correct day (1 = Mon. 7= Sun).
• Press OK, the clock will start.
Xtracom programmable, roomstat and boiler remote control
panel part No. A20077.
Clock Timer and Thermostat Controls:
1 - Days of the week
2 - Override indicator
3 - Low Battery indicator
4 - Time display
5 - Heating in operation
6 - Programme temperature
7 - Room temperature
8 - Programme display
9 - Current programme status
10 - Override / Timed Override button
11 - OK/Enter button
12 - Plus and Minus modification buttons
13 - Manual programme setup buttons
14 - Time set button
15 - Temperature settings button
16 - Programme set button
17 - Cancel/Stand-by button
18 - Boiler Fault LED
PROGRAMME/
THERMOSTAT
DISPLAY
REMOTE
CONTROL
DISPLAY
18
Diagram 3
9328
1 2 3 4 5 6 7
8 9
18 17
14
10
15 16
13
12 11
Presetting the Temperatures T1, T2 and T3
The programmes use three temperature settings which you can
adjust.
Recommended first use settings are:-
T1=16°, T2=19°, T3=21°
If the radiators in your installation are equipped with thermostatic
valves, the highest temperature you can set on T3 is determined
by the highest setting on the radiator thermostatic valves.
e.g. If the highest radiator thermostat valve setting is 21°C then
you must set T3, 2 or 3°C higher, 24°C.
• Press button 15 T1 is displayed.
• Press + or - to set desired temperature.
• Press OK, T2 is displayed.
• Press + or - to set desired temperature.
• Press OK, T3 is displayed.
• Press + or - to set desired temperature.
• Press OK.
Weekly Programming
9329
Diagram 4
9330
Diagram 5
There are 6 preset (P1 to P6) programmes and one manual (P=)
programme which can be assigned to each day of the week (1
to 7), the Factory default setting is P3 on all days. (Programmes
P1 to P6 can not be changed).
• Press button 16 to set day 1 (Monday).
• Press + or - to assign a programme to day 1.
• Press OK