AltiGen MAXCS 7.0 Telephony Hardware - Manual (Page 64)

Vision Access Boards
58 Telephony Hardware Manual
To install a board,
1. Power off the system.
2. Insert the board into the slot you chose, being careful to align the bottom of the
board with the card guides in the bottom of the slot.
Extractor handles
The extractor handles on the board should be in the unlocked, or open, position
(pointing outwards).
Push the board all the way in until the extractor handle grooves capture the side
beams of the slot, and use your thumbs to push the extractor handles in toward the
center to lock the board into place.
When the board is correctly plugged in, the blue light in the faceplate begins to
blink, and the red light is off.
Figure 7. ALTI-VT1E1-2 board
Removing Boards
1. Shut down the AltiGen switching services (from MaxAdmin, choose Services > Shut
Down All Services).
2. Shut down the operating system.
3. Power off the system.
4. Push in the gray release buttons on both side-swing extractor handles.
5. Using your thumbs, push the extractor handles to the side (outwards from center)
and back to release the board.
6. Then grab the handles and pull the board toward you and out.
Swapping a Power Supply
The MAX4000’s three power supplies, located in the back of the unit, are easily accessi-
ble and hot-swappable (removing or adding a power supply without shutting down the
system or MAXCS does not interfere with the operation of the system). Each power sup-
ply has its own power cord.