AltiGen MAXCS 7.0 Telephony Hardware - Manual (Page 56)

MAX2000 System
50 Telephony Hardware Manual
• 30 G.723/G.729/G.711 IP channels, OR
• 12 G.723/G.729/G.711 IP channels plus 48 G.711-only IP channels
When two T1/E1 boards are installed, the configuration will switch to:
• 12 G.723/G.729/G.711 IP channels and 48 G.711-only IP channels
Note: In the event that the installation site grows beyond the supported user size
and you would like to migrate to HMCP Softswitch architecture, the MAX2000
standalone server can be configured in gateway mode. The embedded DSP
will be changed to support the codec listed in MAX2000iG.
• MAX2000iG—in gateway mode, the embedded DSP supports:
• 12 combo codec plus 56 G.711 codec
• Two T1/E1 4x4 access boards or any combination of two access boards
Note: The MAX2000iG cannot be used as a standalone server. The embedded DSP
is hard coded as gateway only.
System Limitation for MAX2000 System
• Trunk recording is not supported. Only extension recording is supported.