AltiGen MAXCS 7.0 AltiConsole - Manual (Page 36)

32 AltiConsole Manual
• Select the Screen Pop check box to have AltiConsole pop up when a
call comes in to your extension.
• Select the Audio Beep check box to hear a beep when a call comes in
to your extension.
• Select the Auto Attendant number to which callers will be sent when
you transfer a call to the Auto Attendant.
You can transfer individual calls to auto attendants other than this
default, as described in “Transfer to Auto Attendant” on page 22.
• Auto Answer - to have AltiConsole automatically answer calls, check
the Enable to auto answer call after check box and click the arrow
buttons to select the number of seconds (0-30).
• For overhead paging, select one of the following options:
• Audio Output (the same as pressing #44 on the phone pad)
• Trunk Paging (the same as pressing #45 on the phone pad). If you
select a trunk line, use the drop-down list to select the trunk to be
used for the overhead paging.
• IP Group Paging (the same as pressing #46 on the phone pad).
• Station Paging
Note: Check with your system administrator about the correct
settings for overhead paging options in AltiConsole.
• Select the Release IP Trunk Link Tie check box to have the Transfer
button send “FLASH *” to release a tie trunk if the incoming call is
through an IP trunk. (Disabled by default.)
Important: Before checking this check box, see your phone system
administrator. If your company is using multiple systems
and the tie trunk feature, the administrator needs to have
used Enterprise Manager to synchronize the systems.
Otherwise this feature will not work.
Note: The call to be transferred must originate from an AltiGen PBX
system running 5.0 or later.
• Select Single Click to Transfer to be able to transfer a highlighted call
using a single click. With this option enabled, when you highlight an
extension and then single-click the call (or double-click any call), the
highlighted call in the Active Calls list is blind transferred to this
extension.