AJA FS1 Version 2.2.0.47 - Manual (Page 84)

74
91.1 Preset Recall
This parameter recalls an FS1 Preset Configuration from memory. Ten named
presets are available
(1–10) .
To recall an FS1 configuration stored in a preset:
1. Use the Select buttons to scroll to parameter 91.1 Preset Recall.
2. Use the Adjust buttons to select a preset (default=1).
3. Press the top Select button to advance to the [UP=Recall] menu field. (Press the
bottom Select button to cancel.)
4. Press the top Adjust button to recall the selected preset.
The display shows [Recalling] and the FS1 reconfigures to the recalled settings. The
display then shows [Recalled].
Caution: When you press Adjust to recall a configuration, the recalled
configuration immediately replaces the system’s existing configuration. All previous
settings are lost unless you have previously stored them in another preset or a file.
92.1 Preset Save
This parameter stores the current FS1 configuration to a Preset Configuration.
There are ten available presets
(1–10) .
To store the current FS1 configuration:
1. Use the Select buttons to scroll to parameter 92.1 Preset Save.
2. Use the Adjust buttons to select a preset (default=1).
3. Press the top Select button to advance to the [UP=Save] menu field. (Press the
bottom Select button to cancel.)
4. Press the top Adjust button to save the configuration to the selected preset.
The display shows [Saving] and the FS1 stores the current configuration into the
preset and displays [Saved]. Presets cannot be named from the front panel. To
change a preset name, refer to the web interface Presets Screen description in Chapter
5. The FS1 displays the same name on the front panel and the web interface.
Parameters Not
Stored Only editable parameters are saved into presets. Example non-editable parameters
that are
not saved include 50.6 MAC Address, 80.1 Serial Number, and 80.2 SW
Version, as well as “trigger” parameters, such as 90.0 Reboot, 91.1 Preset Recall, 92.1
Preset Save, and 99.0 Factory Settings.