AJA FS1 Version 2.2.0.47 - Manual (Page 112)

102
SNMP Screen This screen contains all of the information required to set up SNMP messaging to the
FS1.
FS1 Web Interface, SNMP Screen
SNMP Disabled, Enable 1 or Enable Both (51.1)—Select Enable 1 if you want the FS1
to issue trap messages to the defined trap 1 destination. To issue trap messages to
both Trap 1 and Trap destinations, Select Enable Both. Select Disabled (default)
when you don’t want the FS1 to issue trap messages.
Trap Receivers (51.2 to 51.5)—Enter the IP address of the destination where SNMP
command messages (called “traps”) will be sent (default is 191.168.0.3). This is
usually an SNMP client (“NMS” or Network Management System) somewhere on
your LAN. You must also click the Update submit button to update the FS1 with
the IP address entered here. A Port number for the TCP/IP port to be used for trap
messages from the FS1 to the NMS must also be specified (UDP Port 162 is the
default). Two sets of Trap Destination IP and Port numbers are provided so you
can send trap messages in parallel to two NMS.
Note: Illegal data, such as out of range addresses or text, entered on the SNMP web
page will generate an error page containing a message similar to the following:
Something is missing or out of range
trap IP 1:192.168.0.4
port 1: 162
trap IP 2: 0.0.0.0
port 2: 162
PRESS YOUR BROWSER’S BACK BUTTON TO CONTINUE
Update (Submit button)—Pressing this button requests the FS1 to update its SNMP
information with that entered on this screen.
Update
Firmware The Update Firmware screen and the firmware download and installation procedure are
described in Chapter 3 Installation.