AJA FS1 Version 2.2.0.47 - Manual (Page 46)

36
1.3 Component Out
This parameter defines the output format of the Component Video Output BNC
connectors (Composite Out is a function of Input Format and the 1.3 Component
Out parameter setting).
Notes:
1. Bypass applies to all analog outputs (Component, Composite, and S-Video).
When 1.3 Component Out is set to Bypass, Input signal format is 525i/59.94,
and 5.3 SD Aspect Ratio is set to anything other than Off, the Composite Out
and S-Video outputs will also bypass the Aspect Ratio Converter.
2. Setting parameter 1.3 Component Out to Bypass causes Composite Out to
bypass aspect ratio conversion (parameter 5.3).
3. As in 1.2 SDI2 Out, Bypass mode is not offered in these cases (3:2 Pulldown):
1080pSF/23.98 Input / 1080i/59.94 Output
1080pSF/23.98 Input / 525i/59.94 Output
1080pSF/24 Input / 1080i/60 Output
In these cases, Bypass mode behaves like Normal mode—the output is the same
format as the main SDI1 output.
2.1 Video Input
This parameter performs input video source selection for the FS1. Multiple input
sources may be present at all the connectors on the FS1 rear panel, but the active
input source routed through the FS1 will be the one selected here.
1.3 Component Output Description of Choices
Parameter Adjustments:
Normal (Default)
Bypass (Follow Input)
Standard Def
Component output follows the 1.1 Output Format parameter selection.
Component output follows the format of the selected input.
Notes:
Bypass mode does not work when the input is 1080pSF24 and output is
1080i60 (3:2 pulldown mode).
The signal type of the Component output (RGB versus YPbPr) is defined in another
parameter ( 3.2 Component OUT Format).
The output from Downconverter 2 (see block diagram in Chapter 1) is always
standard definition.
2.1 Video Input Description of Choices
Parameter Adjustments:
SDI 1 (Default)
SDI 2
Composite
S-Video
Component
Select SDI 1 connector as the input source.
Select SDI 2 connector as the input source.
Select the Composite connector as the input source.
Select the S-Video connector as the input source.
Select the Component connector as the input source.