Gradall 534C-10 (2460-4129) Service Manual - Manual (Page 125)

37
Section 4
Assembly and Installation
8. Check trumpet assembly preload and subtract
value obtained before tightening adjusting nut.
Value must be 15-35 lb-in (1.7-4 N•m).
9. Apply Medium Torque liquid adhesive, Loctite
241 or Three Bond 1334, on adjusting nut lock
capscrew threads. Install adjusting nut lock
capscrew. Tighten to 17-23 lb-ft (23.0-30.5 N•m).
10. Install inner washer, planetary gears and rollers
into flange. Figure 4.44.
11. Install outer washers.
12. With correct pliers, install snap rings.
Figure 4.45.
Figure 4.44
Figure 4.45
T
T
13. Apply liquid gasket material on contact surfaces
of trumpet and ring. Figure 4.46.
14. Install ring gear into trumpet. Use reference
marks made during disassembly to align holes
and contact surface. Figure 4.47.
Figure 4.46
Figure 4.47
GASKET