Power Soak 33755 PS-225 Owner's Manual - Manual (Page 28)

24
Facility Owner/Manager Section
The only troubleshooting procedure that the facility
owner or manager can perform is listed immediately
below. All other procedures must be performed by an
authorized service agency. To obtain the name of a
recommended service agent in your area, please call
the Power Soak Service Department at 800-444-9624.
If the wash action will not start or the unit will not maintain temperature:
Check to make sure the main electrical power breaker for the Power Soak
system is in the “ON” position.
Check to make sure the wash tank is filled to the waterline.
Check to make sure that the liquid level sensors are clean and free of any
debris or grease. The liquid level sensors are located on the side walls of
the wash and sanitizer tanks (the white plastic disc with a metal center).
Check to make sure the temperature of the water in the wash tank is below
120F.
If the above trouble shooting procedures do not correct the problem, you must
contact Power Soak Systems, Inc. at 800-444-9624 or an authorized service
agency. Have the serial number of your machine ready when you call.