Power Soak 33755 PS-225 Owner's Manual - Manual (Page 22)

18
Checking the Sanitizer Solution
The sanitizer tank can be set up to prompt concentration checks. If the controller
determines that it is time for a concentration check, the red beacon will flash a
three pulse pattern.
The team member that will be checking the concentration should press the red
STOP/IDLE button. The beacon should change to a steady flashing pattern.
The concentration should be checked. The system will flash steady for a time to
discourage canceling the alert without performing the concentration check. Once
this time has expired the red beacon will become solid.
If the concentration is incorrect, the tank should be drained and refilled. If the
concentration is correct, the red STOP/IDLE button can be pushed to cancel the
alert.
Wash, Rinse and Sanitizer Clean-Up
Between each water change and at the end of each night, all tanks and drain
boards should be thoroughly cleaned with hot, soapy water.
It is also recommended to wipe down all the tanks and drain boards with a
sanitizing agent. Ask your chemical provider to recommend a sanitizer for this
application.