Power Soak 33755 PS-225 Owner's Manual - Manual (Page 18)

14
3. At the completion of the timed wash cycle the green beacon will flash.
The flashing beacon indicates that the timed wash cylce has expired and
an unload/load cycle should be performed.
4. When a team member arrives to perform the unload/load cycle, they
should first press the button on the panel front. The green flashing
beacon will turn solid to acknowledge.
Dry sanitized wares should be moved to their designated storage location.
5. All wares should be removed from the sanitizer tank and arranged for air
drying on the clean drain board.
6. All wares should be removed from the wash tank, rinsed and placed in the
sanitizer tank. When necessary some finishing (light hand scrubbing) may
be necessary.
7. A full load of soiled wares should be scrapped and placed in the wash
tank.
8. When these tasks are complete, press the button on the panel front.
The green flashing beacon will turn off to acknowledge the completion of
the unload/load cycle. The wash timer will be started and the cycle will
repeat. The team member may return to other duties.
Between cycles, soiled wares should be dropped off on the soiled drain board or
other soiled ware landing area.
Loading and Washing Utensils
Each PS-225 Power Soak system comes with a utensil area that is a 6” divided
area in the wash tank. All utensils and other small wares should be loaded into
and washed inside this area.
Do not place knives or other sharp objects in the Power
Soak. Allowing knives or other sharp objects to tumble
freely in the Power Soak tank may cause bodily injury.
Knives and other sharp objects must be washed by
hand with the pump motor turned OFF. Wash, rinse
and sanitize the knife or sharp object, without letting go
of the item and immediately place the item into proper
storage.