4 change the touch screen interface, 5 calibrating the touch screen, Hange the – IEI Integration SRM_121_150 v3.00 User Manual
Page 77: Ouch, Creen, Nterface, Alibrating the, Figure 7-6: finish installation
SRM Series/SRM-KIT Series Monitor
Page 67
Figure 7-6: Finish Installation
7.4 Change the Touch Screen Interface
If the touch screen interface must be changed from an RS-232 interface to a USB
interface or, from a USB interface to an RS-232 interface, the following steps must be
followed.
Step 1:
Uninstall the touch screen driver
Step 2:
Remove the interface cable i.e. remove the RS-232 cable or the USB cable
Step 3:
Install the new cable i.e. install the USB cable or the RS-232 cable.
Step 4:
Reinstall the driver CD as described above.
Step 0:
7.5 Calibrating the Touch Screen
To calibrate the touch screen cursor with the motion of the touch screen pen (or finger),
please follow the steps below:
Step 1:
Make sure the system is properly connected through an RS-232 or a USB
interface to the SRM Series monitor.
Step 2:
Make sure the touch screen driver is properly installed.