IEI Integration SRM_121_150 v3.00 - Manual (Page 50)

SRM Series/SRM-KIT Series Monitor
Page 40
5.5 Mounting the SRM Series LCD Monitor
The SRM series LCD monitor can be mounted in a panel, cabinet, rack, or wall. The
monitor can also be mounted on a monitor arm or stand. The mounting methods are
described below.
CAUTION:
When mounting the monitor take care to tighten the retention screws or
bolts until fully secure, but do not over tighten. Over tightening the
retention screws or bolts may cause them to become stripped,
rendering them useless.
5.5.1 Panel Mounting
To mount the SRM series LCD monitor into a panel, please follow the steps below.
Step 1: Select the position on the panel to mount the monitor.
Step 2: Cut out a section of the panel that corresponds to the rear panel dimensions of
the monitor. Take care that the panel section that is cut out is smaller than the
overall size of the metal frame that surrounds the monitor but just large enough
for the rear panel of the monitor to fit through (Figure 5-5).