C.5.3 model failure, C.5.4 ddc port failure, C.5.4 dcc port failure – IEI Integration LCD-KIT Series v3.00 User Manual

Page 76: Figure c-19: firmware incompatibility, Figure c-20: dcc port failure

LCD-KIT

P a g e 67

C.5.3 Mo d e l Fa ilu re

The Model Fail error message shown below appears.

Figure C-19: Firmware Incompatibility

Solution: SmartOSD only supports firmware version 2.0 and following versions.

C.5.4 DDC P o rt Fa ilu re

The DDC port fail error message shown below appears.

Figure C-20: DCC Port Failure

Solutions:

 Check VGA or DVI cable

 Check an IEI monitor is being used

 Make sure the version is version 2.3 for the AFOLUX/MLCD-KIT series and

version 1.5 for the LCD-KIT/ISLCD-KIT/TLCD-KIT/SRM/LCD-KIT series that

have the SmartOSD functions

 Check if the OSD control status is busy. A busy signal may cause the signal

message for a short time.