6 hdd installation (af-12a-n26 only), Nstallation, Af-12a-n26 – IEI Integration AFL-ххA-N26 User Manual
Page 39
AFL-xxA-N26 Series Panel PC
Page 39
3.6 HDD Installation (AF-12A-N26 Only)
To install the HDD into the AF-12A-N26, please follow the steps below:
Step 1:
Open the system by following the instruction described in Section 3.4.
Step 2:
Remove the four HDD bracket retention screws (Figure 3-9). Disconnect the
SATA cable and the SATA power cable. Lift the HDD bracket off the panel PC.
Figure 3-9: AF-12A-N26 HDD Bracket Retention Screws
Step 3:
Attach the HDD brackets to the HDD. To do this, align the four retention screw
holes in the both sides of the HDD bracket with the retention screw holes on the
sides of the HDD. Insert four retention screws into the HDD bracket
(Figure 3-10). In the mean time, make sure the rear of the HDD is connected to
the SATA cable on the HDD bracket.