3 installation and configuration steps, 4 opening the system, Nstallation and – IEI Integration AFL-ххA-N26 User Manual
Page 34: Onfiguration, Teps, Pening the, Ystem
AFL-xxA-N26 Series Panel PC
Page 34
Anti-static Discharge: If a user open the rear panel of the flat panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1:
Unpack the flat panel PC
Step 2:
Install a mSATA SSD card
Step 3:
Install a HDD (AFL-12A-N26 only)
Step 4:
Configure the system
Step 5:
Connect peripheral devices to the bottom panel of the flat panel PC
Step 6:
Mount the flat panel PC
Step 0:
3.4 Opening the System
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-xxA-N26 internally the back cover and the internal aluminum cover
must be removed. To remove the covers, please follow the steps below.
Step 1:
Remove the retention screws (Figure 3-1) and lift the back cover off the flat
panel PC.