IEI Integration PPC-51xxA-H61 - Manual (Page 66)

PPC-51xxA-H61 Panel PC
Page 51
Step 1: Locate the screw holes on the rear of the PPC-51xxA-H61. This is where the
bracket will be attached.
Figure 3-31: Stand Mounting Retention Screw Holes
Step 2: Align the bracket with the screw holes.
Step 3: To secure the bracket to the PPC-51xxA-H61, insert the retention screws into
the screw holes and tighten them. S te p 0 :
3.12 SFP Fiber Module Installation (Optional)
To install the SFP fiber module, please follow the steps below:
Step 1: Locate the SFP fiber connectors. The locations of the connectors are shown in
Figure 1-5 and Figure 1-6.
Step 2: Align the SFP fiber module with one of the SFP fiber connectors on the
PPC-51xxA-H61 (
7
Figure 3-32 ).
Step 3: Once aligned, slide the SFP module into place (
7
Figure 3-32 ).