IEI Integration PPC-51xxA-H61 - Manual (Page 64)

PPC-51xxA-H61 Panel PC
Page 49
Figure 3-29: Tighten the Panel Mounting Clamp Screws
3.11.3 Rack and Cabinet Installation
To mount the PPC-51xxA-H61 into a rack/cabinet, please follow the steps below.
Step 1: Secure the rack mounting bracket to two sides of the monitor using the supplied
retention screws. Each bracket requires four screws.
Step 2: Secure the rack mounting bracket to the rack by inserting and tightening the
supplied mounting nuts and bolts. Each bracket requires three nuts and bolts for
installation. Step 0:
3.11.4 Arm Mounting
The PPC-51xxA-H61 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100 mm interface pad. To mount the PPC-51xxA-H61
on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.