5 stand mounting, Figure 3-30: arm mounting retention screw holes – IEI Integration PPC-51xxA-H61 User Manual

Page 65

PPC-51xxA-H61 Panel PC

Page 50

NOTE:

When purchasing the arm please ensure that it is VESA compliant and

that the arm has a 100 mm interface pad. If the mounting arm is not

VESA compliant, it cannot be used to support the PPC-51xxA-H61

panel PC.

Step 2:

Once the mounting arm has been firmly attached to its surface, lift the

PPC-51xxA-H61 panel PC onto the interface pad of the mounting arm.

Step 3:

Align the retention screw holes on the mounting arm interface with those in the

PPC-51xxA-H61 panel PC. The arm mounting retention screw holes of the

PPC-51xxA-H61 panel PC are shown in Figure 3-30.

Figure 3-30: Arm Mounting Retention Screw Holes

Step 4:

Secure the PPC-51xxA-H61 to the interface pad by inserting four retention

screws through the mounting arm interface pad and into the PPC-51xxA-H61

panel PC.

Step 0:

3.11.5 Stand Mounting

To mount the PPC-51xxA-H61 using the stand mounting kit, please follow the steps

below.