Adaptec ANA-5940 - Manual (Page 130)

B-12
ANA-5910/5930/5940 User’s Guide
ANA-5910/5930/5940 User’s Guide
Stock Number: 510694-00, Rev. C
Page: B-12
Print Spec Number: 493081-00
Current Date: 5/28/97
ECN Date: 05/29/97
Note: The selftest and SAR memory tests check most of the
functionality on the adapter. To test all functions on the
adapter, use a loopback cable and run the external ATM test.
To verify that the adapter is functioning properly, do the following:
1 Make sure you have installed the adapter and the drivers. See
Chapter 3, Installing the Adapter.
2 Select the MS-DOS Command Prompt icon in the Main
program group.
3 Change to the directory where ATM software is installed. The
default is
\etc\opt\adptaatm\bin .
4 Stop all the drivers that are running. See Database File
Parameters on page B-14.
5 Start the diagnostic utility by entering the following command:
aatmdiag
For help, enter aatmdiag -h from the MS-DOS command prompt,
or type help when you are in the diagnostic command utility (at
the ADM:0> prompt).
When using the loop mode of testing, type loop. At the
LoopMode> prompt, enter the desired test. At the next
LoopMode> prompt, enter the next desired test. When you
have finished, enter end. If you wish to display the
intermediate pass results of your tests, be sure to enter
log_level 1 before you enter loop mode. For example
ADM:0> log_level 1
ADM:0> loop
LoopMode> selftest
LoopMode> sar_mem_e
LoopMode> atm_ext
LoopMode> end
6 Execute the adapter selftest by entering the following
command from the ADM:0> prompt:
ADM:0> selftest
Self Tests
PASSED