General Pump KS Repair Manual - Manual (Page 8)

GENERAL PUMP
A member of the Interpump Group
KS SERIES
The shim pack must be redefined as follows:
Insert the crankshaft in the crankcase, being sure that the PTO shank comes out of the correct side. Fit the
PTO side flange to the crankcase paying great attention to the seal lip as indicated in paragraph 2.1.2.
Position the flange on the sight glass side as indicated in paragraph 2.1.2 using a thickness gauge
(see fig. 11).
Page 8
Ref 300902 Rev.A
07-12
Determine the shim pack as indicated in the table below:
Measurement Shim Type No. of Pieces
From: 0.05 to: 0.10 / /
From: 0.11 to: 0.20 0.1 1
From: 0.21 to: 0.30 0.1 2
From: 0.31 to: 0.35 0.25 1
From: 0.36 to: 0.45 0.35 1
From: 0.46 to: 0.55
0.35
0.10
1
1
From 0.56 to: 0.60 0.25 2
From 0.61 to: 0.70
0.35
0.25
1
1
Insert the shims of the cover on the sight glass side )see fig. 12), fixing it to the crankcase using the
appropriate screws, and verifying that the stall torque is between 3-5 ft. lbs. (4-7 Nm).
If the torque value is correct, connect the rods to the crankshaft; otherwise, redefine the shims again
repeating operations.