General Pump KS Repair Manual - Manual (Page 18)

GENERAL PUMP
A member of the Interpump Group
KS SERIES
Page 18
Ref 300902 Rev.A
07-12
2.2.5 Head assembly - seals - plunger unit
To reassemble the various components, invert the previously listed operations as indicated in paragraph
2.2.3, paying particular attention to:
The sealing packs: respect the same order of disassembly.
Lubricate the components (2,3 and 5, fig. 40) with OCILIS type silicone grease part #F12001600; this
operation is considered necessary to facilitate the settling of the sealing lips on the plunger.
For correctly assembling the HP seals in their related seats on the head without damaging the lips, use the
appropriate tools depending on the pumping assembly diameters as indicated in Chapter 4.
Reassemble the plungers by fastening the screws with an appropriate torque wrench, respecting the
fastening torque value indicated in Chapter 3.
Assemble the head: for fastening torque values and fastening sequences, respect the indications of
Chapter 3.