General Pump KS Repair Manual - Manual (Page 6)

GENERAL PUMP
A member of the Interpump Group
KS SERIES
Page 6
Before assembling the cover (sight glass side), be sure that the shim rings have been inserted. To help the
covers fit onto the crankcase, we advise to use 3 screws M6x40, and then finish the operation with the
screws supplied (M6x18) as shown in 1, fig. 7.
Install the connecting rod cap respecting numbering, and fasten the relavant bolts (lubricating both
the head and the threaded stem) proceeding in three different steps, see fig. 8:
1. Approaching torque 4.4-6 ft. lbs. (6-8 Nm)
2. Pre-fastening torque 18.4-20.6 ft. lbs. (25-28 Nm)
3. Fastening torque 28 ft. lbs. (38 Nm)
Install the rear cover positioning the oil dipstick hole upward. Fill the crankcase with oil as indicated in the
Owner’s Manual in Section 7.4.
Ref 300902 Rev.A
07-12