General Pump KS Repair Manual - Manual (Page 12)

GENERAL PUMP
A member of the Interpump Group
KS SERIES
Verify the conditions of the sealing lip of the pinion oil wiper; replace if necessary using the tool part
#F27904800.
Page 12
2.1.3 Version change - Application / removal of the reducer unit
To change the version and apply the reducer unit where not foreseen, it’s necessary to remove the shaft oil
wiper (1, fig. 29) and insert the reducer unit Ø8 reference pin on the crankshaft (1, fig. 29). Therefore
proceed with the operations specified in paragraph 2.1.5.
To change the version and remove the reducer unit where expected, it’s necessary to insert the shaft oil
wiper using the tool part #F27904800 (1, fig. 29).
Ref 300902 Rev.A
07-12
If the shaft presents diameter wear corresponding
to the sealing lip, to avoid the need for grinding
it’s possible to position the ring as indicated in
fig. 28.
After completely assembling the reducer unit,
verify the rolling of the pinion.