John Deere STARFIRE RTK OMPFP11348 - Manual (Page 48)

900 MHz RTK—Original GreenStar Display
JS56696,00007FC -19-15APR10-1/2
JS56696,00007FC -19-15APR10-2/2
Operating Vehicle
IMPORTANT: The base station receiver and vehicle
receiver must be setup before operating RTK.
See Setup sections for setup procedures.
When vehicle receiver is powered-up, No GPS, No Diff
will be displayed on RUN - TRACKING - PAGE screen
until an initial position is determined. When base station
transmits correction signal, 3D RTK will be displayed on
RUN - TRACKING - PAGE screen.
NOTE: If communication loss is WITHIN first hour of
base station operation, Extend Mode will provide
RTK accuracy for two minutes.
Communication loss AFTER first hour of base
station operation, Extend Mode will provide
RTK accuracy for 15 minutes.
A——
B——
C——
D—— E—Track Number, Error
F— —
G—3D RTK, Shift Track, Mark
Point
PC9562
—UN—12MA
Y09
RUN - Tracking - PAGE 3
Extend Mode (RTK-X): If communication between base
station and vehicle radio is lost for more than 10 seconds,
vehicle receiver will automatically switch to Extend Mode
and will maintain RTK accuracy for a period of time.
RTK-X will be available for approximately 2 to 15 minutes
if base station has been powered up for less than 1 hour.
If base station communication is not re-established after
Extend period, receiver will default to WAAS, or NO DIFF
where WAAS is not available.
A——
B——
C——
D—— E—Track Number, Error
F— —
G—3D RTK, Shift Track, Mark
Point
RUN
JOHN DEERE
Tracking
A
B
C
D
E
F
G
PAGE 3
Track
No.
356-W Error
(ft)
0.0
Mark
Point
Shift Track 3D
RTK-X 3 2 1
PC9565
—UN—06NOV06
RUN - Tracking - PAGE 3
30-9 121511
PN=48