John Deere STARFIRE RTK OMPFP11348 - Manual (Page 47)

900 MHz RTK—Original GreenStar Display
JS56696,00007FA -19-15APR10-1/1
JS56696,00007FB -19-15APR10-1/1
Network ID
NOTE: 4000 network ID's are available (default ID is 1).
Screen: SETUP - RTK
Press: SETUP >> StarFire 3000 >> DIFF CORRECTION
SETUP >> RTK SETUP
Network ID for base station and vehicle receiver must
match. If more than one base station with same Network
ID numbers are within range, vehicle may lock on to either
one of base stations. To prevent this from happening, be
sure to use unique network ID.
A—RTK Operating Mode
B—RTK Radio Channel
C—RTK Network ID
D—— E—Submit
F— —
G—Return to RTK Setup
PC12085
—UN—13MA
Y09
SETUP - RTK
Repeater
NOTE: The radio can be configured to act separately
as repeater. A repeater is required if obstructions
(i.e. trees, hills, etc.) exist between base
station and vehicle(s).
A repeater consists of:
• Radio (configured as a repeater)
• Harness
• Mounting Bracket
• 12 Volt Power Source
To configure radio as repeater:
Screen: SETUP - RTK
Press: SETUP >> StarFire 3000 >> DIFF CORRECTION
SETUP >> RTK SETUP
1. Connect radio to receiver RTK harness.
2. Check that receiver has GPS position calculated.
3. Check that base station, vehicle, and repeater have
same Frequency, Network ID and Radio Channel.
4. Toggle RTK Operating Mode to Repeater.
5. Radio will configure as repeater.
6. Disconnect repeater from receiver and wiring harness.
7. Reconnect original radio.
PC12086
—UN—13MA
Y09
SETUP - RTK
A—RTK Operating Mode
B—RTK Radio Channel
C—RTK Network ID
D—— E—Submit
F— —
G—Return to RTK Setup
8. Toggle Mode to Vehicle.
30-8 121511
PN=47