John Deere STARFIRE RTK OMPFP11348 - Manual (Page 42)

900 MHz RTK—Original GreenStar Display
JS56696,00007F6 -19-15APR10-1/1
Continued on next page JS56696,00007F7 -19-15APR10-1/3
Quick Survey Mode
NOTE: Display is not required after base station
receiver has been configured to operate in Quick
Survey Base Mode and RTK Frequency, Radio
Channel/Network ID have been set.
Connect display to base station..
Screen: SETUP - RTK
Press: SETUP >> StarFire 3000 >> DIFF CORRECTION
SETUP >> RTK SETUP
NOTE: Quick Survey Base Mode allows base
station to broadcast corrections after receiver
calculates GPS position.
If power is removed from base station (but not
moved) power can be restored and same base
station position will be used for corrections. If
previously used Track 0 is recalled in Parallel
Tracking/Auto Trac no Shift Track will be needed.
If power is removed and base station is moved, a new
position will be calculated when power is restored.
If previously used Track 0 is recalled in Parallel
Tracking/Auto Trac, use Shift Track. (See AutoTrac
Operator's Manual for Shift Track procedures.)
Press letter button next to RTK OPERATING MODE and
toggle to QUICK SURVEY BASE MODE.
PC12081
—UN—13MA
Y09
SETUP - RTK
A—RTK Operating Mode
B—RTK Radio Channel
C—RTK Network ID
D—— E—Submit
F— —
G—Ruturn to RTK setup
Absolute Mode
IMPORTANT: Absolute Base Mode requires base
receiver to be mounted in a rigid position.
Tripod is not recommended.
NOTE: Display is not required after base station
receiver has been configured to operate in
Absolute Survey Base Mode and RTK Radio
Channel/Network ID have been set.
Connect display to base station.
Screen: SETUP - RTK
Press: SETUP >> StarFire 3000 >> DIFF CORRECTION
SETUP >> RTK SETUP
Press letter button next to RTK OPERATING MODE and
toggle to ABSOLUTE SURVEY BASE MODE.
A—RTK Operating Mode
B—RTK Radio Channel
C—RTK Network ID
D—— E—Submit
F— —
G—Return to RTK Setup
PC12082
—UN—13MA
Y09
SETUP - RTK
30-3 121511
PN=42