John Deere STARFIRE RTK OMPFP11348 - Manual (Page 29)

900 MHz RTK—GS2 Display
DK01672,00001BE -19-11NOV11-2/2
Base Station Data (Information)
Operator can view the following:
Base Station Data in information that will be displayed
when in Quick survey Base or Absolute Base Mode.
• Status
- OK—Base Station is transmitting correction.
- No Stored Base—24 hour self survey is required for
current location.
- Initializing—Receiver is initializing radio, acquiring
GPS signal.
- Self Survey—24 hour self survey in progress.
• Sat. Corrections – Indicates number of GPS satellites
for which base station is transmitting correction.
• Distance – Difference between base station location
(known position) and location indicated by uncorrected
GPS. Displayed in miles (kilometers).
• Direction – Direction from base station location (known
position) to location indicated by uncorrected GPS.
Displayed in degrees with true North as 0 degrees.
• Base Battery – Base Station voltage. Displayed in volts.
Radio Data and Connection
Signal Level – Level of signal which is detected at radio.
Select Refresh button to refresh signal level.
Vehicle Mode – Base Station Data
NOTE: Information that will be displayed when
in Vehicle Mode.
• Status
- OK – Base Station is transmitting correction.
- No Stored Base – 24 hour self survey is required for
current location.
- Initializing – Receiver is initializing radio, acquiring
GPS signal.
- Self Survey – 24 hour self survey in progress.
- No Signal – Vehicle RTK radio is not receiving signal
from base station.
• Sat. Corrections – Indicates number of GPS satellites
for which base station is transmitting correction.
• Distance – Difference from base station to vehicle
receiver. Displayed in miles (kilometers).
• Direction – Direction in degrees to base station.
Displayed in degrees with true North as 0 degrees.
• Base Battery – Base Station voltage. Displayed in volts.
Radio Data and Connection
• Signal Level – Level of signal which is detected at radio.
Press Refresh button to refresh signal level.
• Data Received (%) – Percent of received correction to
vehicle from base station.
Indicates source of correction. If there is no correction,
this will toggle between base and repeater. There is also a
TOGGLE button for manual toggle between two sources.
25-4 121511
PN=29