Inter-Tel INT4000 - Manual (Page 22)

10 INT4000 Cordless Telephone User Guide
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your phone directly on a wall.
Before mounting your phone, consider the following:
• Select a location away from electrical cables, pipes, or other items behind the
mounting location that could cause a hazard when inserting screws into the wall.
• Ensure the wall material is capable of supporting the weight of the base unit.
• Use #10 screws with anchoring devices suitable for the wall material where the
base unit will be placed.
To mount the base unit on a wall:
1. Insert two mounting screws 3 15/16 inches (10 cm) apart. Allow
about 3/16 of an inch (0.5 cm) between the wall and screw heads
for mounting the phone, as shown on the right.
2. Follow steps 2 and 3 on the previous page to plug and secure the
AC adapter cord.
3. Plug one end of the telephone line cord into the LINE jack
on the base unit. Then place the telephone cord inside the
molded channel(s) on the bottom of the wall mount stand.
4. Place the base unit on the posts of the wall
screws and push down until it’s firmly
seated, as shown on the right.
5. Plug the other end of the short telephone
cord into a telephone wall jack.
6. Follow step 7 on the previous page to plug
the AC adapter into a standard 120V AC
wall outlet.