Adjusting the height of the cantilever arms – Invacare Adjustable ASBA Seat User Manual
Page 46
SECTION 8—ARMS
46
Adjusting the Height of the Cantilever Arms
NOTE: For this procedure, refer to FIGURE 8.4.
1. Adjust the angle of the cantilever arms to allow access to the hardware that attaches
the mounting brackets to the back canes. Refer to Adjusting the Angle of the
Cantilever Arms.
2. Loosen the three screws that secure the back cane mounting bracket to the back cane.
Repeat to loosen the opposite back cane mounting bracket.
3. Adjust the position of mounting brackets and spreader bar up or down the back cane
to desired height.
4. Tighten the screws on both back cane mounting brackets to secure the back cane
mounting brackets at the desired height obtained in STEP 3.
5. Adjust the angle of the cantilever arms to accommodate the user. Refer to Adjusting
the Angle of the Cantilever Arms on page 47.
FIGURE 8.4 Adjusting the Height of the Cantilever Arms
Screws
(STEP 2)
Back Cane Mounting Bracket
Adjust angle of Cantilever Arm
(STEP 1)