Section 6—front riggings, Installing/removing footrests, Ph904a, phal4a, 70° and – Invacare Adjustable ASBA Seat User Manual
Page 24
SECTION 6—FRONT RIGGINGS
24
SECTION 6—FRONT RIGGINGS
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustments or service, ALWAYS turn the
wheelchair power off, otherwise injury or damage may result.
Installing/Removing Footrests
PH904A, PHAL4A, 70° and PW93
NOTE: For this procedure, refer to
FIGURE 6.1.
1. Turn the footrest to the side (open
footplate is perpendicular to
wheelchair).
2. Install the hinge plates on the footrest
onto the hinge pins on the wheelchair
frame.
3. Push the footrest towards the inside of
the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
FIGURE 6.1 Installing/Removing Footrests -
4. Repeat STEPS 1‐3 for other footrest assembly.
5. To remove the footrest, push the footrest release lever inward, rotate footrest outward.
6. Adjust footrest height if desired. Refer to Adjusting the Footrest Height on page 25.
Footrest Release
Lever
Hinge Plate
Footrest
Hinge
Pins