Removing installing – Invacare Adjustable ASBA Seat User Manual

Page 40

SECTION 7—POWER ELEVATING LEGRESTS

Removing/Installing the Power Elevating Legrest
Harness

NOTE: For this procedure, refer to FIGURE 7.9 on page 41.

Removing

1. Unplug the power elevating legrest connector from the harness.

2. Unplug the harness from the TRECM or DLIAM.

3. Cut the tie‐wrap securing the harness to the rear harness wire bracket.

4. Remove the two cap screws and locknuts securing the harness connector to the front

harness wire bracket.

Installing

1. If power legrests were not previously installed, perform the following steps:

A. Remove the hex screw and washer securing the front of the rear arm socket to the

seat frame.

B. Install the rear harness wire bracket onto the front mounting hole on the rear arm

socket using the hex screw.

NOTE: The hex screw will install into the T‐nut in the seat frame.

C. Install the hex screw through the washer and front harness wire bracket and into

the T‐nut in the seat frame.

D. Repeat STEPS A‐C for the opposite side of the wheelchair.

2. Secure the power elevating legrest connector to the front harness wire bracket using

the two cap screws and locknuts.

3. Tie‐wrap the harness to the rear harness wire bracket (Detail “A”).

4. Plug the harness into the TRECM or DLIAM.

5. Repeat STEPS 2‐4 for the opposite side of the wheelchair.