Adjusting the calf pad – Invacare Adjustable ASBA Seat User Manual
Page 38
SECTION 7—POWER ELEVATING LEGRESTS
38
Adjusting the Calf Pad
Adjusting the Calf Pad Width
NOTE: For this procedure, refer to FIGURE 7.5.
1. Remove the two button head screws from the calf pad and calf pad bracket.
2. Reposition calf pad to calf pad bracket to desired mounting position.
3. Align button head screws to mounting holes on calf pad and calf pad bracket.
4. Install button head screws into calf pad bracket and calf pad. Securely tighten.
5. Repeat STEPS 1‐4 for opposite side if necessary.
FIGURE 7.5 Adjusting the Calf Pad Width
Adjusting the Calf Pad Depth
NOTE: For this procedure, refer to
FIGURE 7.6.
1. Loosen, but DO NOT remove, hex
screws.
2. Slide calf pad assembly up and out of
the channel.
3. Remove the flat head socket screw, and
locking hex nut that secure the calf
bracket to the depth adjustment
bracket.
4. Reposition the calf bracket on the depth
adjustment bracket to desired position.
5. Install the flat head socket screw
through the calf bracket, depth
adjustment bracket and locking hex
nut.
FIGURE 7.6 Adjusting the Calf Pad Depth
6. Tighten locking hex nut to screw until snug. DO NOT overtighten nut or calf pad will
not pivot properly.
Back View
of Legrest
Calf Pad Bracket
Calf Pad
Mounting
Holes
Button
Head
Screws
Calf Pad
Button
Head
Screws
Calf Pad Bracket
Mounting
Holes
Channel
Depth
Adjustment
Holes
Flat Head
Socket
Screw
Locking
Hex
Nut
Calf
Bracket
Depth
Adjustment
Bracket
Hex
Screws
NOTE: Calf pad not shown for clarity.