Installing/removing elevating legrests, Installing removing – Invacare Adjustable ASBA Seat User Manual

Page 32

SECTION 6—FRONT RIGGINGS

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 6.14.

Installing

1. Turn legrest to side (open footplate is perpendicular to wheelchair).

2. Install the legrest hinge plates onto the hinge pins on the wheelchair frame.

3. Rotate legrest toward the inside of the wheelchair until it locks in place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4. Repeat STEPS 1‐3 for the opposite

legrest.

5. After the user is seated in wheelchair,

adjust footplate to correct height by
loosening nut and sliding the lower
footrest assembly up or down until
desired height is achieved.

Removing

1. Push the legrest release handle toward

the inside of the wheelchair (facing the
front of the wheelchair).

2. Swing the legrest to the outside of the

wheelchair.

3. Lift up on the legrest and remove from

the wheelchair.

4. Repeat STEPS 1‐2 for opposite side of

wheelchair.

FIGURE 6.14 Installing/Removing Elevating

Legrest Release Handle

Bolt/Nut

Calfpad

Legrest

Hinge Plates

Hinge Pins