Invacare Adjustable ASBA Seat User Manual

Page 28

SECTION 6—FRONT RIGGINGS

Adjusting/Replacing Telescoping Front Rigging Support

ƽ WARNING

If the telescoping tubes need to be extended greater than two inches, then the seat
MUST be repositioned rearward to ensure stability - otherwise personal injury and/
or damage to the wheelchair and surrounding property may result.

NOTE: For this procedure, refer to FIGURE 6.8.

1. Remove the two cap screws, spacers and threaded blocks securing the telescoping

front tube to the side rail.

2. Perform one of the following:

• Slide existing telescoping front rigging support to one of six depth positions.
• Remove existing telescoping front rigging.

3. Secure the telescoping front tube to the side rail at the desired depth with the existing

two cap screws, spacers and threaded blocks.

4. Repeat STEPS 1 to 3 on the opposite side if desired.

FIGURE 6.8 Adjusting/Replacing Telescoping Front Rigging Support

Telescoping

Front Tube

Cap Screws

Spacers

Threaded

Blocks

Cap Screws

Spacers

Side Rail