Invacare Adjustable ASBA Seat - Manual (Page 35)

SECTION 7—POWER ELEVATING LEGRESTS
Part No 1143238 35 Adjustable ASBA Seat
6. If necessary, adjust powered legs. Refer to Adjusting the Power Elevating Legrests
below.
Removing the Power Elevating Legrests
1. Disconnect power legrests from the harness.
2. Push powered legrest release handle toward the opposite side of the wheelchair and
swing legrest to the outside of the wheelchair.
3. Lift powered legrest and remove from wheelchair.
4. Repeat STEPS 1‐3 for opposite power legrest.
FIGURE 7.1 Installing/Removing the Power Elevating Legrests
Adjusting the Power Elevating Legrests
Adjusting the Footplate
ƽ WARNING
DO NOT remove heel loops without providing some other adequate means of
support. Otherwise personal injury may occur.
Adjusting the Footplate Height
NOTE: For this procedure, refer to FIGURE 7.2 on page 36.
NOTE: The following procedure should be performed with the user in the wheelchair.
NOTE: T‐nuts ride in the channels of the exterior/interior rails of the power legrests. Refer to
FIGURE 7.2.
1. Loosen, but DO NOT remove, the two interior button screws that secure the footplate
assembly to the T‐nuts.
Calf Pad
Footplate
Legrest Release
Handle
Mounting
Hole
DETAIL “A” DETAIL “B”
Jumper
Cable
Power
Legrest
Connector
Mounting Pin