Invacare 6908A User Manual
Safety summary
Part No. 1125025
1
MPR Push Handle Pad Kit
MPR Push Handle Pad Kit - Model
6905A,6907A, 6908A
Assembly, Installation and Operating Instructions
Kit No. 1124321, 1124322
SAVE THESE INSTRUCTIONS
NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact
Carrier/Dealer for further instruction.
SAFETY SUMMARY
To ensure the safe installation, operation and use of the MPR Push Handle Pad
Kit, these instructions MUST be followed:
GENERAL WARNING
DO NOT install or use this equipment without first reading and understanding
these instructions. If you are unable to understand the Warnings, Cautions or
Instructions, contact a healthcare professional, dealer or technical personnel before
attempting to install this equipment - otherwise injury or damage may occur.
INSTALLATION WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
MODELS 6905A AND 6907A
Push Handle Pad Kit (Part No. 1124321) contains the following items:
DESCRIPTION
QUANTITY
Push Handle Pad
2
REPLACING PUSH HANDLE PADS - MODELS 6905A AND
6907A (FIGURE 1)
1. Remove the two (2) hex screws that
secure the push handle to the back
frame.
2. Cut the existing push handle pads and
remove.
3. Clean the push handle and apply a small
amount of dish soap on the push handle.
4. Work the new push handle pads onto
the push handle until they are
completely in place.
5. Secure the push handle to the back
frame using the existing hardware.
For more information regarding Invacare products, parts, and services,
please visit: www.invacare.co
m
FIGURE 1 - REPLACING PUSH
HANDLE PADS - MODELS 6905A
AND 6907A
Back
Cushion
Push Handle
Pads
Push Handle
Back
Frame
Hex
Screws