Fujitsu Siemens Computers LifeBook A6210 - Manual (Page 80)

80 - Memory Upgrade Module
Checking the Memory Capacity
Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your notebook has recognized the change.
Check the memory capacity by clicking [Start] > Control Panel > System and Maintenance > System.
The amount of memory is displayed next to “Memory - RAM:”
There may be a variation between the actual memory size and what is displayed. This is possible if your
system is configured with a graphics card that dynamically allocates system memory to accelerate
graphics performance.
Removing a Memory Module
1 Perform steps 1 through 4 of Installing a
Memory Upgrade Module.
2 Pull the clips sideways away from each
side of the memory upgrade module at the
same time.
3 While holding the clips out, remove the
module from the slot by lifting it up and
pulling it away from your notebook.
4 Store the memory upgrade module in a
static guarded sleeve.
5 Replace the cover and reinstall the screws.
Figure 35. Removing memory module
I F THE TOTAL MEMORY DISPLAYED IS INCORRECT , CHECK THAT YOUR MEMORY UPGRADE MODULE IS
PROPERLY INSTALLED . (I F THE MODULE IS PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT
CORRECTLY RECOGNIZED , SEE T ROUBLESHOOTING ON PAGE 86.
Memory Clip