Fujitsu Siemens Computers LifeBook A6210 - Manual (Page 169)

170 - Introducing the Optional Fingerprint Sensor Device
Basic Enrollment
The Enrollment Wizard will guide you through the process of enrolling a user. Unless you specified
otherwise, after OmniPass installation the Enrollment Wizard will launch on Windows login. If you do
not see the Enrollment Wizard, you can bring it up by clicking Start on the Windows taskbar; select
Programs; select Softex; click OmniPass Enrollment Wizard.
1 Click Enroll to proceed to username and password verification. By default, the OmniPass Enrollment Wizard
enters the credentials of the currently logged in Windows user.
2 Enter your Windows log-in password. This will become the “master password” for this OmniPass user. In most
cases, the Domain: value will be your Windows computer name. In corporate environments, or when accessing
corporate resources, the Domain: may not be your Windows computer name. Click [Next] to continue.
3 In this step OmniPass captures your fingerprint. Refer to “Enrolling a Fingerprint” on page 170 for additional
information.
4 Next, choose how OmniPass notifies you of various events. We recommend you keep Taskbar Tips on
Beginner mode taskbar tips and Audio Tips on at least Prompt with system beeps only until you get
accustomed to how OmniPass operates. Click [Next] to proceed with user enrollment. You will then see a
Congratulations screen indicating your completion of user enrollment.
5 Click [Done] to exit the OmniPass Enrollment Wizard. You will be asked if you’d like to log in to OmniPass with
your newly enrolled user; click [Yes].
Enrolling a Fingerprint
Enrolling a fingerprint increases the security of your system and streamlines the authentication procedure.
You enroll fingerprints in the OmniPass Control Center. With an OmniPass user logged in, double-click
the system tray OmniPass icon. Select User Settings tab and click Enrollment under User Settings area.
Click Enroll Authentication Device and authenticate at authentication prompt to start device enrollment.
1 During initial user enrollment, you are prompted to select the finger you wish to enroll. Fingers that have already
been enrolled will be marked by a green check. The finger you select to enroll at this time will be marked by a
red arrow. OmniPass will allow you re-enroll a finger. If you choose a finger that was already enrolled and
continue enrollment, OmniPass will enroll the fingerprint, overwriting the old fingerprint. Select a finger to enroll
and click [Next].