Hughes Satellite IP Modem R-BGAN - Manual (Page 22)

Note: If you are in an overlap region of the satellite’s coverage, the pointing screen will show
two satellites, two compass directions, and two antenna angles.
Antenna Pointing Screen – Satellite Overlap Region
Try pointing to the IOR satellite first and check the signal quality meter as you point the antenna
following Steps 7-8. Do not exit antenna pointing at this point in time. Next try pointing to the
AOR satellite and again check the signal quality meter as you point the antenna following Steps
7-8. Pick the satellite with the highest signal quality reading and then re-point the antenna
following Steps 7-8. Once this is complete, you can proceed to Step 9 and Exit Pointing. If the
network is not acquired after exiting pointing, reboot the modem and try pointing to the other
satellite.
R-BGAN Satellite IP Modem User Manual 12