Humax IR-ACE M - Manual (Page 45)

Guide of Main Menu
Automatic Search
The function of the Automatic Search menu is to search services
using information from a satellite.
The following items are supplied as parameters.
Specifies the satellite in which the automatic search will be
performed.
Enables/disables the automatic skip option. If this option is enabled,
the scrambled services are skipped during the search.
Specifies search type. If the search type is “Detail”, then four symbol
rates are added and used during the search.
Upsets up to four symbol rates for searching when the search type
is “Detail”.
To automatically search the services, proceed as follows:
1. Activate the Automatic Search menu.
2. Set all the parameters according to the satellite information.
3. Press the OK ( ) button to start the search.
4. Press the EXIT ( ) button to cancel during the search.
The Automatic Search may take a long time to search all the
services, depending on the parameter settings.
Since the Automatic Search is based on hard-coded information,
this information is properly updated to search all services.
To obtain the updated information, please consult the HUMAX web
site.
Antenna Alternative
Automatic Skip
Search Type
Symbol Rate table(optional)
GB44